BITBUS terminators

RS485 lines require termination on the extreme ends of the bus. The following DB9 dummy connectors contain termination and HF-wise earthing of the signal ground.

10.12 € *

PER-BITTERM<F

Female termination plug, mates male socket

10.12 € *

PER-BITTERM<M

Male termination plug, mates female socket

Cables for BITBUS installation

1.53€*⁄m

KAB-BIT

BITBUS cable with two twisted stranded wire pairs and overall shield. For use in the master segment or in all applications without repeaters. LiYCY(B) 2x2x0,25mm2.

1.94€*⁄m

KAB-BIT

BITBUS cable with three twisted stranded wire pairs and overall shield. For use in slave segments. LiYCY(B) 3x2x0,25mm2.

Assembled BITBUS cables

Shielded 3 pair twisted pair cable with one male and one female DB9 connector. Use to interconnect two nodes or to prolongate another cable.

12.68 € *

KKB-BITF9M9<2m

Two metres long

17.79 € *

KKB-BITF9M9<5m

Five metres long

23.01€*+1.94€*⁄m

KKB-BITF9M9<nm

Special length cable made to order.

The book

BITBUS: Grundlagen und Praxis / Frank J. Furrer et al. Heidelberg: Hüthig, 1994. ISBN 3-7785-2250-7

Unfortunately only in german language available is a book about BITBUS fundamentals and application. It covers specification and topology of BITBUS, an excerpt from the IEEE1118 standard, RAC/GBS commands, multitasking and message passing, programming and planning of distributed control applications. Samples of typical applications are shown and protocol implementations on various hardware is presented. Installation and troubleshooting completes this helpful book.

39.88 € *

HDB-BITBUS

* all prices in EUR ex works (+VAT/MwSt inside Germany)